BHT-700QWB-CE/700QWBG-CE
1.1 System Configuration
This section describes the hardware required for the 2D code/barcode data collection system used by the BHT and
the BHT software.
1.1.1 Hardware Configuration
In addition to the BHT, the following hardware is required for the 2D code/barcode data collection system
used by the BHT.
Please note that certain components of the required hardware will differ depending on the type of
communication used.
Refer to "Chapter 3 Basic Preparation" – "3.4 Transmitting Data" for detail.
Bluetooth®-enabled
devices (option)
Wireless base station
2
Wireless LAN access point
(option)
®
Bluetooth
communication
BHT
GPRS and EDGE
communication*
CU-733 or CU-714
(option)
Ethernet
Wireless
communication
Infrared
communication
Connector
communication
CU-733 : RS-232C or USB
CU-714 : Ethernet
*BHT-700QWBG-CE only
Host computer