Table of Contents
Advertisement
BHT-700QWB-CE/700QWBG-CE
2.1 "BHT Preparation" Procedure
Follow the steps below to prepare the BHT.
2.2
Loading and Charging the Battery
Cartridge(Page 16)
2.3 Attaching the Stylus (Page 23)
2.4 Initial Setup
(Page 25)
2.2 Loading and Charging the Battery Cartridge
The battery cartridge is not charged when purchased and should therefore be charged prior to use.
The chargers that can be use with the BHT are the communication units (CU-733, CU-714) and battery chargers
(CH-751, CH-704).
* The CH-704 charger is used for charging individual batteries, and the CH-751 is a stand-type (same type
as CU (communication unit)) charger.
The charge time is approximately 3 hours (standard rechargeable battery cartridge) or 6 hours
(large-capacity rechargeable battery cartridge).
An only slightly discharged battery cartridge should take less time to become fully charged.
Charging Precautions
• Do not touch the BHT, battery, or charger terminals by hand or stain them. Doing so could result
in a contact failure or prevent charging.
• Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger's protective device, preventing charging, and lead
to protective device damage, overheating, blowout or combustion.
• Terminate charging if not completed even after the specified time has elapsed.
16
First load and charge the battery cartridge.
Attach the stylus to prevent it from being lost.
Calibrate the touch screen and set the calendar clock
when the power is turned ON for the first time.
Advertisement
Table of Contents
