Table of Contents
Advertisement
Wireless Information
Wireless Properties
Tap the "Wireless Information" tabbed page at the wireless network
settings menu to display the screen on the right.
The SSID list for which a search was performed automatically by the BHT
displays.
If the SSID is not automatically recognized, double-tap "Add New..." and
manually enter the SSID.
Tap the SSID for which a connection is to be made from the SSID list, and
then tap the [Connect] button to begin connecting to the wireless
network.
When there are no settings for connection to the selected wireless
network, the settings screen described in the following section displays.
Double-tap an SSID from the SSID list to display the screen on the right.
Settings required to connect to the wireless network are made at this
screen.
Network name (SSID):
Enter the SSID. Manually enter the SSID if it is not automatically
recognized.
This is an ad hoc network:
Do not select this check box because ad hoc mode is not supported.
Encryption:
Select the encryption method.
Authentication:
Select the authentication method when the encryption method is selected.
Network key:
Enter the WEP Key when the encryption method is WEP.
Enter the Pre Shared Key when the authentication method is WPA-PSK.
Key index:
Enter the network key index (1 to 4).
This key is provided automatically:
Select this check box to automatically obtain the network key.
Enable 802.1X authentication:
Select this check box to enable IEEE 802.1X authentication.
EAP type:
Select the "Enable 802.1X authentication" check box to enable selection.
Refer to "Authentication Settings" on the following page for further details.
2D Code Handy Terminal
111
Advertisement
Table of Contents
