Installing The Drain Line; Priming The Drain Trap; Wiring The Unit For Power - Wine Guardian D050 Installation, Operation And Maintenance Manual

Installing the Drain Line

 The drain line must extend from the unit to an external drain or disposal site.
Do not use drain tubing any smaller than one-half inch inside dimension on the unit.
 Splice the drain extension onto the drain outlet with a sort piece of one-half inch
copper tubing and secure with claps.
 If no drain is available, use a bucket. Do not extend the drain below the rim of
the bucket. Empty the bucket periodically.
The Wine Guardian unit is provided with a built-in drain trap. The drain trap creates a water seal to
prevent air from backing up into the drain pan and causing the drain pan to overflow. Do not create
secondary traps in the external drain line.
Allow enough height for the drain line to function properly. If draining into a nearby sink, the unit
must be elevated higher than the rim of the sink in order for the water to drain by gravity. Install
with a one-quarter inch per linear foot of pitch. Do not tie the condensate drain line directly into the
sanitary sewer system. See Accessories and Optional Equipment section for information about the
condensate pump.

Priming the Drain Trap

The internal drain trap primes itself automatically once the unit has run for a period of time and after
the unit cycles off. This is confirmed by water dripping from the drain.

Wiring the Unit for Power

DO:
 Match the electrical wiring to the cord provided on the Wine Guardian. 
 Provide dedicated circuit and wiring for the system.
 Match the wiring and breaker size to the rated load as shown on the serial plate
and in this guide. See sample serial plate illustration on the following page.
ELECTRICAL SHOCK HAZARD
RISK OF SERIOUS INJURY OR DEATH
The electrical outlet and wiring installation must meet the
national and local building codes.
DANGER
29