F Inal Adjustments - Datasat AP20 Installation And Operating Manual

2.13 Final Adjustments
After performing the EQ, take another SPL level reading. If the SPL reading has changed, use the Level
control (Third Octave EQ screen) to raise or lower to the proper SPL level for each channel (see Table
10 on page 3 7 ) .
X X X
2.14 Copy Format
When a format has been configured, you may want to copy it to the next format, as a starting point, to
save time in configuring the next format. For details, see
Menu (System) > Formats > Edit Formats > Copy Format
Figure 22. Audio Format Edit, Copy Format
For details about Copy Preset to Format, see 2.8.1 Preset Formats, page 30.
2.15 Setting up Multiple Screens
After setting up one screen (auditorium) you can copy the setup parameters including format names,
channel assignments and EQ settings to other screens. This minimizes the time required for installing
similar theaters since many of the values may be the same.
To do this, save the setup configuration on a memory stick (USB Flash drive), then use the saved setup
to copy to the AP20 for the next screen, since many or all the values will be the same.
Menu (System) > System Setup > USB Save/Restore > Save on USB > Master
Configuration
See S aving and Restoring Configuration Files
X
2.16 Using Dirac Live® to Tune the Auditorium
®
See the Dirac Live Theater Setup Guide for detailed instructions. The Dirac Live
separate tool, available from Datasat Digital Entertainment but not supplied with the AP20 processor.
AP20 Installation & Operating Guide
AP20 Installation and Operating Guide
E dit Formats , page 6 2 .
X X X X
, page 5 5 for more details.
X X X
Document # 9301H39200 Ver. 1.2
Page 42
®
application is a