Power; Ethernet Ports; Table 2-1 Power Supply Unit Inlet Operating Range; Table 2-2 Ethernet Connection Transfer Rates - Sun Microsystems Fire V250 Installation Manual

Power

Caution – The socket-outlet (receptacle) must be installed near the equipment and
be easily accessible.
The Sun Fire V250 has a single AC inlet, or dual AC inlets if redundant power
supplies are installed. The AC inlets are on the rear of each power supply unit. The
operating ranges are given in
source, the server is in Standby power mode. The only way to turn server power
fully off is to remove the server from the power source by disconnecting the power
cable.
Power Supply Unit Inlet Operating Range
TABLE 2-1
Input Parameter
AC input voltage
AC input frequency

Ethernet Ports

The Sun Fire V250 server has one autonegotiating 10/100/1000BASE-T Ethernet
system domain interface, the transfer rates for which are given in
uses a standard RJ-45 connector
Ethernet Connection Transfer Rates
TABLE 2-2
Connection Type
Ethernet
Fast Ethernet
Gigabit Ethernet
In addition, the server has one 10BASE-T Ethernet management domain interface,
labeled NET MGT, which is reserved for server management. For information about
configuring this port for use with ALOM, see the ALOM Online Help which is
included on the Sun Fire V250 Server Documentation CD.
. While the server is connected to a power
TABLE 2-1
AC Inlet
90V to 264V (power systems with nominal
voltages of 100V to 240V)
47 Hz to 63 Hz (power systems with
nominal frequencies of 50 Hz or 60 Hz)
.
IEEE Terminology
10BASE-T
100BASE-T
1000BASE-T
TABLE 2-2
Transfer Rate
10 Mbit/s
100 Mbits/s
1000 Mbit/s
Chapter 2 Installing the Hardware
. The port
13