Connecting To The Server Using A System Running Microsoft Windows; To Connect To The Server - Sun Microsystems Fire V250 Installation Manual

2. Make the following setting changes:
Property
Duplex
Bit Rate
Parity
Data Bits
Stop Bit
Flow Control
VT100 Emulation
For information about how to power on and configure the server, see "Powering On
the Server" on page 26.
Connecting to the Server Using a System
Running Microsoft Windows
If you want to configure and operate a Sun Fire V250 server from a PC or laptop
running Microsoft Windows, you can do so using the Windows Hyperterminal.
Note – The following procedure relates to Windows 98. Other variants of Microsoft
Windows may differ slightly.
Note – Hot Sync Manager must be closed. If it is open, you will not be able to
communicate with the server from your PC or laptop.

To Connect to the Server

1. Connect the RJ-45 patch cable to the port labeled SERIAL MGT on the rear of the
server.
2. Connect the other end of the patch cable to the DB-9 adapter.
Setting
Full
9600
No
8
1
None
On (if applicable)
Chapter 3 Communicating With The Server 23