Sun Microsystems Fire V250 Installation Manual page 38

3. Connect the DB-9 serial adapter to the COM1 serial port on your PC or laptop.
4. Open a Windows Hyperterminal:
a. Choose Start > Programs > Accessories > Communications > Hyperterminal
b. Run Hyperttrm.exe
5. In the Set Up New Session window:
a. Name the session.
b. Choose an icon.
c. Click OK.
6. In the Connect To window:
a. Click Edit.
b. Click Connect Using.
c. In the drop-down menu, click Direct to COM1.
Note – If you connected the DB-9 adaptor to a port other than COM1 on your PC or
laptop, choose the appropriate option from the list in the drop-down menu.
d. Click OK.
7. In the COM1 Properties window:
a. Change the Bits Per Second value to 9600.
b. Set Flow Control to Xon/Xoff.
The correct values for all settings in this window are as shown below.
Property
Bits Per Second
Data Bits
Parity
Stop Bits
Flow Control
c. Click OK.
The sc> prompt appears in the Windows Hyperterminal.
24 Sun Fire V250 Server Installation Guide • September 2003
Setting
9600
8
None
1
Xon/Xoff