Displaying Time Code; Presetting And Recording Of Time Code - JVC GY-DV5001 Instructions Manual

10. TIME CODE OPERATION
The GY-DV5000 records EBU-standard time codes and user's bits. In the play mode or the record mode, the reproduced time
codes or user's bits are shown on the LCD monitor or in the viewfinder.
● Time code data cannot be output through the unit's connectors.

10-1 Displaying Time Code

OPEN
LCD BRIGHT DISPLAY
AUDIO
LEVEL PULL
OPEN
FRONT
REAR
CH-1 CH-2
CH-1 CH-2
AUDIO INPUT
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL
Time code indication
00:00:00:00
STBY 01/02/03 01:23:45
Status 1 screen

10-2 Presetting and Recording of Time Code

The time codes from the internal time code generator can be recorded at the time of recording scenes.
Whether or not user's bit data should be recorded can be selected with the UB REC item on the TC/UB/CLOCK menu screen.
OPEN
LCD BRIGHT DISPLAY
AUDIO
LEVEL PULL
OPEN
FRONT
REAR
CH-1 CH-2
CH-1 CH-2
AUDIO INPUT
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL
TC/UB/CLOCK menu screen
––– TC/UB/CLOCK –––
TC PRESET 00:00:00:00
EXECUTE
TC CLEAR CANCEL
UB PRESET 00 00 00 00
EXECUTE
UB CLEAR CANCEL
UB REC ON
HEADER REC..
TIME/DATE..
PAGE BACK
E-64
COUNTER switch
LCD BRIGHT DISPLAY
MONITOR
SELECT
COUNTER
CH-1
MIX FRONT TC
CH-2 REAR
UB
AUDIO
CH-1 CH-2
CH-1 CH-2
LEVEL AUDIO INPUT
AUDIO SELECT
AUDIO INPUT
CH-1 CH-2 TC GENE.
FRONT REAR
AUTO REGEN FREE
LINE
MIC MANUAL REC
+48V PRST
Example
Time code indication
00:00:00:00
User's bits indication
FF EE DD 20
LCD BRIGHT DISPLAY
MONITOR
SELECT
COUNTER
CH-1
FRONT TC
MIX
CH-2 REAR
UB
AUDIO CH-1 CH-2
CH-1 CH-2
LEVEL AUDIO INPUT
AUDIO SELECT
AUDIO INPUT
CH-1 CH-2 TC GENE.
FRONT REAR
AUTO
LINE REGEN FREE
REC
MIC MANUAL
+48V
PRST
TC GENE. switch
The time codes or user's bits can be shown on the LCD monitor
or in the viewfinder during playback and recording as follows.
(Status screen)
Setting
1.
Set the TC/UB item on the LCD/VF (2/2) menu screen to
ON.
● Time codes or user's bit data are displayed on the Status
screen.
2.
Whether time codes or user's bit data should be displayed
is selected with the COUNTER switch inside the cover on
the side.
TC : Time codes are displayed.
UB : User's bit data is displayed.
To preset the Time Code, make the following settings.
TC GENE. switch
Set to PRST REC or PRST FREE.
PRST REC : The data preset in the time code generator
runs only during recording.
Use this setting if it is necessary to record
continual time codes across different
scenes.
* However, approximately ±1-frame
variations may occur in scene accuracy.
PRST FREE : The time code starts to run from the time it
is preset in the time code generator.