Power Supply - JVC GY-DV5001 Instructions Manual

Using an Anton-Bauer Battery Pack
To use an Anton-Bauer battery pack (Propack 13/14, Trimpack 13/14, Magnum 13/14, Compack 13/14 Series), it is necessary to
detach the battery case from the GY-DV5000 and replace it with the Anton-Bauer battery holder. Use the following battery holder.
• Battery holder: Anton-Bauer QRQ27
Detaching the Battery Case From the GY-DV5000 and Attaching The Anton-
Bauer Battery
2.
1.
Black screw A
1.
Remove the two black screws A on the battery case.
2.
Remove the lower half of the battery case cover in the
downward direction.
3.
Mount screw B
3.
Mount screw B
3.
To remove the battery case, remove the four screws B
fixing the battery case and the connector connecting the
battery case to this unit.
Attaching and Detaching an Anton-Bauer Battery Pack
Cassette cover side panel
Guide holes
(x3)
Release
lever
Side panel
with display
3.
Connector
Guide pins
Battery pack
(Trimpack)
LCD BRIGHT
AUDIO
LEVEL
CH-2
CH-1
AUDIO INPUT
AUDIO SELECT
CH-1
Attaching the Anton-Bauer Battery Holder
5.
5.
Anton-Bauer
Battery holder
4.
Connect the connectors protruding from the GY-DV5000
with the connectors on the battery holder.
CAUTION:
Following connection of the connectors, insert them into
the connector compartment.
Take care not to pinch the wires. This could result in
damage.
5.
Secure the battery holder to the GY-DV5000 with the four
mount screws provided with the battery holder.
Attaching the Battery Pack
1.
Align the 3 guide pins of the battery pack with
the guide holes on the battery holder, and push
straight to insert the battery pack.
The battery cannot be attached properly if the
Release lever
guide pins are not inserted straight.
2.
Slide the battery pack toward the side panel
where the cassette cover is located until it clicks.
Now the battery pack has been attached.
OPEN
DISPLAY
Detaching the Battery Pack
PULL
OPEN
FRONT
REAR
CH-2
CH-2
AUTO
MANUAL
While pushing the release lever, slide the battery
pack toward the side panel where the LCD display
Battery
is located, then pull the battery pack outward to
remove.

4. POWER SUPPLY

4.
Connector
Compartment
E-35