Turning The Power On - JVC GY-DV5001 Instructions Manual

5. PREPARATIONS

5-1 Turning the Power ON

1.
Set the POWER switch to ON.
The unit turns on in Camera mode.
The operation differs according to whether the unit is in the Camera mode or in the VTR mode.
When the MODE switch is pressed upward, the mode is changed.
The Camera indicator or VTR indicator comes on in accordance with the selected mode.
Mode
Camera mode
VTR mode
Turning the Power OFF
1.
Place the GY-DV5000 in the record-standby or STOP mode.
2.
Set the POWER switch to OFF.
3.
Remove the battery pack or the power supply to the DC IN connector. (When the camera is not going to be used for a longer
period.)
CAUTION:
● Do not set the POWER switch to OFF while recording is taking place.
Confirm that the STBY or STOP indication is shown in the VTR operation mode indication area before the power is turned
off.
Should the POWER switch accidentally be set to OFF during a recording, wait at least 5 seconds before turning the power
on again.
● Always set the POWER switch to OFF before disconnecting the power supply
Do not turn the battery pack or AC power supply OFF while the POWER switch on the camera is still set to ON.
EDITSEARCH
MONITOR
FILTER
1 3200K
2 5600K / 1 8 ND
5600K
.3
.4 5600K / ND 1 64
STATUS
SHUTTER
LCD BRIGHT
MENU
AUDIO
LEVEL
FRONT
AUTO IRIS FULL AUTO BLACK LOLUX REAR
CH-1 CH-2
CH-1 CH-2
MODE AUDIO INPUT
BACK L STRETCH AUDIO SELECT
VTR
NORMAL NORMAL CH-1 CH-2
SPOT L COMPRESS AUTO
CAM MANUAL
POWER
VTR
ON OFF
The GY-DV5000 enters the Camera mode. The camera image is displayed in the viewfinder
or on the LCD monitor. When a recordable videocassette is loaded, the GY-DV5000 enters
the record-standby mode automatically. "STBY" is displayed in the VTR operation mode
indication area of the LCD monitor or in the viewfinder. In this condition, press the VTR trigger
button to start recording.
* Playback is also possible in the Camera mode.
Playback operation becomes possible when the STOP button is pressed to set the VTR
operation mode indicator to indicate STOP.
The GY-DV5000 enters the VTR mode. The camera image will not be displayed in the
viewfinder or on the LCD monitor. When a videocassette is loaded, the GY-DV5000 enters
the stop mode.
"STOP" is displayed in the VTR operation mode indication area of the LCD monitor or in the
viewfinder.
DV input is possible through the DV terminal. (GY-DV5001 only)
MENU
AUTO IRIS FULL AUTO
BACK L
NORMAL
SPOT L
OPEN
DISPLAY
PULL
OPEN
POWER
ON
POWER
switch
Operation
BLACK LOLUX
MODE
STRETCH
VTR
NORMAL
COMPRESS
CAM
VTR
OFF
MODE
indicator
MODE
switch
E-37