Turning On/Off The Power - JVC Connected Cam GY-HC900CHU Instructions Manual

Turning On/Off the Power

Turning On the Power
.
1 Set the [POWER ON/OFF] switch to "ON".
The camera recorder starts up in Camera mode
and is ready for shooting.
Memo :
The camera recorder always start up in Camera
0
mode when the [POWER ON/OFF] switch is set to
"ON". Use the [CAM/MEDIA] button at the side of
the camera recorder to switch mode.
(A P20 [Operation Modes] )
Turning Off the Power
Sets the camera recorder to the recording standby or
stop mode.
1 Set the [POWER ON/OFF] switch to "OFF".
2 Remove the battery and the power to the [DC
INPUT] terminal (when not in use for a long
time).
Caution :
Do not set the [POWER ON/OFF] switch to "OFF"
0
during recording. Check that the operation mode
display is "STBY" or "STOP" before you turn off the
power.
If you have mistakenly set the [POWER ON/OFF]
0
switch to "OFF" during recording, wait for 5
seconds or more before you turn on the power
again.
When turning off the power, first set the [POWER
0
ON/OFF] switch of the camera recorder to "OFF".
Do not remove the battery or turn off the AC power
while the [POWER ON/OFF] switch is set to "ON".
Turning On/Off the Power
37