Figure 37: Hspa Modem Faceplate - RuggedCom RuggedRouter RX1000 Family Installation Manual

4.12.2 HSPA (GSM) Cellular Modem Card
The HSPA card option is available for use on various GSM based networks. It is
available in either Slot 5, or Slot 6 of the RuggedRouter. This option supports GSM,
GPRS, EDGE, UMTS and WCDMA/HSDPA/HSUPA. Main antenna and Receive
Diversity antenna connections are made to the 50 Ω SMA connectors located on
either side of the front faceplate (see Figure 37). Supported frequency bands are
shown in Table 18. Ensure that the maximum antenna gain is not exceeded for safe
operation of the device.

Figure 37: HSPA Modem Faceplate

SIM card access is available on the front faceplate of the HSPA module (see Figure
37). Instructions for installing the SIM are as follows:

Remove power from the unit.

Remove the SIM protective cover marked "HSPA" by unscrewing the two
screws on either side with a #2 Phillips screwdriver.

Insert the SIM with the angled side first. An audible click will indicate that the
SIM is in position.

Slide the latch over the SIM to secure it in place.

Reattach the SIM protective cover.
Band
Tx (MHz)
Band I
1920-1980
WCDMA 2100
Band II
1850-1910
WCDMA 1900
Band V
824-849
WCDMA 850
Band VI
830-840
WCDMA 800
GSM 850 824-849
EGSM 900 880-915
GSM 1800 1710-1785
GSM 1900 1850-1910
®
RuggedRouter RX1000 Family
Frequency Range
VSWR Rx (MHz)
<2.5:1 2110-2170
<2.5:1 1930-1990
<2.5:1 869-894
<2.5:1 875-885
<2.5:1 869-894
<2.5:1 925-960
<2.5:1 1805-1880
<2.5:1 1930-1990
41
Communication Ports
RX
Diversity
VSWR
Support
<3.5:1 Y
<2.5:1 Y
<3.5:1 Y
<3.5:1 Y
<3.5:1
<3.5:1
<3.5:1
<2.5:1
®
RuggedCom
Maximum
Allowable
Gain (dBi)
4
4
5
5
5
5
4
4
- Rev.122