Cabletron Systems SmartSwitch 8-slot User's Reference Manual page 70

Chapter 5: OSPF Configuration Guide
In the configuration shown in Figure 1 on page 5 - 12, suppose if we decide to run RIP
Version 2 on network 120.190.0.0/16, connecting routers R1 and R2.
We would like to redistribute these RIP routes as OSPF type-2 routes, and associate the
tag 100 with them. Router R1 would also like to redistribute its static routes as type 2
OSPF routes. The interface routes would redistributed as type 1 OSPF routes.
Router R1 would like to redistribute its OSPF, OSPF-ASE, RIP, Static and Interface/
Direct routes into RIP.
1. Enable RIP on interface 120.190.1.1/16.
rip add interface 120.190.1.1
rip set interface 120.190.1.1 version 2 type multicast
2. Create a OSPF export destination for type-1 routes.
ip-router policy create ospf-export-destination
3. Create a OSPF export destination for type-2 routes.
ip-router policy create ospf-export-destination
4. Create a OSPF export destination for type-2 routes with a tag of 100.
ip-router policy create ospf-export-destination
5. Create a RIP export source.
ip-router policy export destination ripExpDst source
6. Create a Static export source.
ip-router policy create static-export-source statExpSrc
7. Create a Direct export source.
ip-router policy create direct-export-source directExpSrc
8. Create the Export-Policy for redistributing all interface, RIP and static routes into
OSPF.
ip-router policy export destination ospfExpDstType1 source
ip-router policy export destination ospfExpDstType2 source
ip-router policy export destination ospfExpDstType2t100
9. Create a RIP export destination.
5 - 10
ospfExpDstType1 type 1 metric 1
ospfExpDstType2 type 2 metric 4
ospfExpDstType2t100 type 2 tag 100 metric 4
ripExpSrc network all
directExpSrc network all
statExpSrc network all
source ripExpSrc network all
SSR User Reference Manual