Creating An Export Destination - Cabletron Systems SmartSwitch 8-slot User's Reference Manual

Chapter 6: Routing Policy Configuration Guide
complex filter requirements, then use the second method.
After you create one or more building blocks, they are tied together by the iprouter
policy export command.
To create route export policies, enter the following command in Configure mode:
Create an export policy.
The
<exp-dest-id>
where the routes are to be exported. If no routes to a particular destination are to be
exported, then no additional parameters are required.
The
<exp-src-id>
determines the source of the exported routes. If a export-policy for a given export-
destination has more than one export-source, then the ip-router policy export
destination <exp-dest-id> command should be repeated for each
The
<filter-id>
export-policy. If there is more than one route-filter for any export-destination and
export-source combination, then the ip-router policy export destination <exp-dest-id>
source <exp-src-id> command should be repeated for each

Creating an Export Destination

To create an export destination, enter one the following commands in Configure mode:
Create a RIP export destination.
Create an OSPF export destination.
6 - 16
ip-router policy export destination <exp-dest-id>
[source <exp-src-id> [filter <filter-id> |[network
<ipAddr-mask> [exact|refines|between <low-high> ]
[metric <number> |restrict]]]]
is the identifier of the export-destination which determines
, if specified, is the identifier of the export-source which
, if specified, is the identifer of the route-filter associated with this
ip-router policy create rip-export-
destination < name>
ip-router policy create ospf-export-
destination < name>
<exp-src-id>
.
<filter-id>
SSR User Reference Manual
.