Monitor Tacacs; Configure Passwords; L2 Security Filters - Cabletron Systems SmartSwitch 8-slot User's Reference Manual

Chapter 9: Security Configuration Guide
Determine TACACS action if no server
responds.
Enable TACACS.

Monitor TACACS

You can monitor TACACS configuration and statistics within the SSR.
To monitor TACACS, enter the following commands in Enable mode:
Show TACACS server statistics.
Show all TACACS parameters.

Configure Passwords

The SSR provides password authentication for accessing the User and Enable modes.
If TACACS is not enabled on the SSR, only local password authentication is
performed.
To configure SSR passwords, enter the following commands in Configure mode:
Set User mode password.
Set Enable mode password.

L2 Security Filters

Layer-2 security filters on the SSR allow you to configure ports to filter specific MAC
addresses. When defining a Layer-2 security filter, you specify to which ports you
want the filter to apply. You can specify the following security filters:
• Address filters
These filters block traffic based on the frame's source MAC address, destination
MAC address, or both source and destination MAC addresses in flow bridging
mode. Address filters are always configured and applied to the input port.
9 - 2
tacacs set last-resort password|succeed
tacacs enable
tacacs show stats
tacacs show all
system set password login <string>
system set password enable <string>
SSR User Reference Manual