Monitoring Rip - Cabletron Systems SmartSwitch 8-slot User's Reference Manual

Chapter 4: RIP Configuration Guide
routes from other protocols into RIP, you must explicitly specify a value for the
default-metric parameter. The metric specified by the default-metric parameter may be
overridden by a metric specified in the export command.
To configure default-metric, enter the following command in Configure mode.
Define the metric used when advertis-
ing routes via RIP that were learned
from other protocols.
For
<num>

Monitoring RIP

The rip trace command can be used to trace all rip request and response packets.
To monitor RIP information, enter the following commands in Enable mode.
Show all RIP information.
Show RIP export policies.
Show RIP global information.
Show RIP import policies.
Show RIP information on the specified
interface.
Show RIP interface policy information.
Show detailed information of all RIP
packets
Show detailed information of all pack-
ets received by the router.
Show detailed information of all pack-
ets sent by the router.
Show detailed information of all
request received by the router.
4 - 4
rip set default-metric <num>
, you must specify a number between 1 and 16.
rip show all
rip show export-policy
rip show globals
rip show import-policy
rip show interface <Name or IP-addr>
rip show interface-policy
rip trace packets detail
rip trace packets receive
rip trace packets send
rip trace request receive
SSR User Reference Manual