Redistributing Directly Attached Networks; Redistributing Rip Into Rip; Redistributing Rip Into Ospf - Cabletron Systems SmartSwitch 8-slot User's Reference Manual

Table of Contents

Chapter 6: Routing Policy Configuration Guide

To redistribute static routes, enter one of the following commands in Configure mode:

To redistribute static routes into RIP.

To redistribute static routes into OSPF.

Redistributing Directly Attached Networks

Routes to directly attached networks are redistributed to another routing protocol such

as RIP or OSPF by the following command. The network parameter specifies a set of

routes that will be redistributed by this command. If all direct routes are to be

redistributed set the network parameter to all. Note that the network parameter is a

filter that is used to specify routes that are to be redistributed.

To redistribute direct routes, enter one of the following commands in Configure mode:

To redistribute direct routes into RIP.

To redistribute direct routes into OSPF.

The SSR routing process requires RIP redistribution into RIP if a protocol is

redistributed into RIP.

To redistribute RIP into RIP, enter the following command in Configure mode:

To redistribute RIP into RIP.

RIP routes may be redistributed to OSPF.

To redistribute RIP into OSPF, enter the following command in Configure mode:

To redistribute RIP into OSPF.

6 - 10