Cabletron Systems SmartSwitch 8-slot User's Reference Manual page 63

To configure OSPF interface parameters, enter one of the following commands in
Configure mode:
Enable OSPF state on interface.
Specify the cost of sending a packet
on an OSPF interface.
Specify the priority for determining
the designated router on an OSPF
interface.
Specify the interval between OSPF
hello packets on an OSPF interface.
Configure the retransmission inter-
val between link state advertisements
for adjacencies belonging to an
OSPF interface.
Specify the number of seconds
required to transmit a link state
update on an OSPF interface.
Specify the time a neighbor router
will listen for OSPF hello packets
before declaring the router down.
Disable IP multicast for sending
OSPF packets to neighbors on an
OSPF interface.
Specify the poll interval on an OSPF
interface.
Specify the identifier of the key chain
containing the authentication keys.
Specify the authentication method to
be used on this interface.
SSR User Reference Manual
Chapter 5: OSPF Configuration Guide
ospf set interface < name-or-IPaddr >|all
state disable|enable
ospf set interface < name-or-IPaddr >|all cost
<num>
ospf set interface < name-or-IPaddr >|all
priority <num>
ospf set interface < name-or-IPaddr >|all
hello-interval <num>
ospf set interface < name-or-IPaddr >|all
retransmit-interval <num>
ospf set interface < name-or-IPaddr >|all
transit-delay <num>
ospf set interface < name-or-IPaddr >|all
router-dead-interval <num>
ospf set interface < name-or-IPaddr >|all no-
multicast
ospf set interface < name-or-IPaddr >|all
poll-interval <num>
ospf set interface < name-or-IPaddr >|all key-
chain <num-or-string>
ospf set interface < name-or-IPaddr >|all
authentication-method none|simple|md5
5 - 3