5. Push inward on the two left tabs of the operator information panel until it pops
To install the operator information panel, reverse the previous steps.
Speaker and bracket
Note: Read "Before you begin" on page 41 and "Safety information" on page 129.
Complete the following steps to remove the speaker and bracket:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover (see "Removing the cover of the 6226" on page 60).
3. Rotate the diskette drive cage up.
Note: It might be necessary to use the tip of a screwdriver to disengage the
lower tab.
free of the chassis; then, remove it from the computer, making sure that the
cable follows freely.
and power cords.
Release
latch
Retainer slots
FRU information (service only)
89