IBM NetVista
WOL1/WOM1: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with the card to plug into
the system board WOL1 connector. This enables the Wake On LAN (WOL)
feature. When your system is in a power-saving mode, any LAN signal
automatically resumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin
Signal Name
1
5VSB
2
Ground
3
SENSE
If you have installed a modem, use the cable provided with the modem to plug
into the system board WOM1 connector. This enables the Wake On Modem
(WOM) feature.
When your system is in a power-saving mode, any modem signal automatically
resumes the system. You must enable this item using the Power Management
page of the Setup Utility.
J1: ExtSMI connector
The ExtSMI connector is for use with SMI hardware interrupt power management.
Pin
Signal Name
1
EXTSMI
2
GND
SPEAKER1: Internal speaker
Connect the internal speaker connector to this header.
Pin
Signal Name
1
External speaker
2
Onboard buzzer
3
NC
4
VCC
29/53