Table of Contents
Advertisement
Beep/symptom
3-3-3 (No operational memory in
system.)
No-beep symptoms
No-beep symptom
No beep occurs during POST.
No beep, no video, and the
system attention LED (if
present) is off.
No beep, no video, and the
system attention LED (if
supported) is on.
BIST failed.
Diagnostic error codes
Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
Error code/symptom
001-XXX-000 (Failed core tests)
001-XXX-001 (Failed core tests)
001-250-000 (Failed system board ECC)
001-250-001 (Failed system board ECC)
005-XXX-000 (Failed video test)
011-XXX-000 (Failed COM1 serial port test) 1. Check loopback plug connected to externalized serial port.
011-XXX-001 (Failed COM2 serial port test) 1. Check loopback plug connected to externalized serial port.
014-XXX-000 (Failed parallel port test)
FRU/action
1. Install or reseat the memory modules, and then do a 3-boot reset.
(For more information about a 3-boot reset, see "Using the
Configuration/Setup Utility program" on page 11.)
2. DIMMs.
3. System board.
FRU/action
v System board
v System board
v See "Undetermined problems" on page 117.
v Microprocessor
FRU. The description for these error codes are:
000
The test passed.
195
The Esc key was pressed to stop the test.
197
Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
FRU/action
v System board
v System board
v System board
v System board
1. Video adapter (if installed)
2. System board
2. Check cable from externalized port to system board.
3. System board.
2. Check cable from externalized port to system board.
3. System board.
v System board
97
Symptom-to-FRU index
Advertisement
Table of Contents
