Table of Contents
Advertisement
10. Slide the drive into the drive bay, and then attach the drive to the drive cage.
11. Connect one end of the diskette or IDE signal cable into the back of the drive
12. Connect the power cable to the back of the drive. The connectors are keyed
13. If you have other options to install or remove, do so now.
14. Replace the cover (see "Replacing the cover of the 6216" on page 55).
15. Reconnect the external cables and power cords; then, turn on the attached
Installing a hard disk drive
Complete the following steps to replace a hard disk drive in your computer:
52
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual
and the other end of the cable into the diskette drive or IDE connector on the
system board. For the location of the diskette or IDE connectors, see "System
board internal cable connectors" on page 44.
Note: Make sure to route the signal cable so that it does not block the airflow
to the rear of the drives or over the microprocessor.
and can be inserted only one way.
devices and the computer.
1. Read the information in "Preinstallation steps" on page 49.
2. Turn off the computer and attached devices and disconnect the external cables
and power cords.
3. Remove the cover and frame-support bracket (see "Removing the cover of the
6216" on page 45 and "Removing the frame-support bracket" on page 45).
4. Disconnect the power and signal cables from both drives in the drive cage.
Advertisement
Table of Contents
