10. Replace the cover (see "Replacing the cover of the 6216").
11. Reconnect the external cables and power cords. Turn on the attached devices,
Installing a security rope clip
To help prevent theft, you can add a rope clip and cable to the computer.
Complete the following steps to install the rope clip:
1. Review the safety precautions listed in "Safety information" on page 129.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
6. Replace the cover (see "Replacing the cover of the 6216").
7. Reconnect the external cables and power cords, and turn on the attached
Replacing the cover of the 6216
Complete the following steps to replace the computer cover:
1. Clear any cables that might impede the replacement of the cover.
7. If there is a gap between the DIMM and the retaining clips, the DIMM has not
been correctly installed. Open the retaining clips, remove the DIMM, and then
reinsert it.
8. If you have other options to install or remove, do so now.
9. Replace the frame-support bracket.
and turn on the computer.
and power cords; then, remove the cover (see "Removing the cover of the
6216" on page 45).
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, make sure that it does not interfere with other
cables connected to the computer.
devices, then the computer.
Rope clip
55
Installing options