Table of Contents
Advertisement
Software problem
Symptom
Suspected software problem.
Universal Serial Bus (USB) port problems
Symptom
A USB device does not work.
POST error codes
In the following error codes, X can be any number or letter.
Error code/symptom
062 (Three consecutive boot failures using
the default configuration.)
101, 102, 106 (System and processor
error)
114 (Adapter read-only memory error)
151 (Real time clock error)
161 (Real time clock battery error)
106
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual
FRU/action
1. To determine if problems are caused by the software, verify that:
v The computer has the minimum memory needed to use the software. For
memory requirements, see the information that comes with the software.
Note: If you have just installed an adapter or memory, you might have a
memory address conflict.
v The software is designed to operate on the computer.
v Other software works on the computer.
v The software that you are using works on another system.
If you received any error messages when using the software program, see the
information that comes with the software for a description of the messages and
suggested solutions to the problem.
2. If you have verified these items and the problem remains, contact your place of
purchase.
FRU/action
v Verify that:
– You are not trying to use a USB device during POST if you have a standard
(non-USB) keyboard attached to the keyboard port.
Note: If a standard (non-USB) keyboard is attached to the keyboard port, the
USB is disabled and no USB device will work during POST.
– The correct USB device driver is installed.
– The operating system supports USB devices.
FRU/action
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
4. Microprocessor.
v System board
1. Failing adapter.
2. Run diagnostics.
1. Run diagnostics.
2. Battery.
3. System board.
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
Advertisement
Table of Contents
