IntelliStation E Pro Type 6226
The following section contains instructions for removing components from the
IntelliStation E Pro Type 6226.
Main rear fan
Note: Read "Before you begin" on page 41 and "Safety information" on page 129.
Complete the following steps to remove the main rear fan:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover (see "Removing the cover of the 6226" on page 60).
3. Disconnect the fan cable from the system board.
4. On the outside of the chassis, use side cutters to sever the four rubber
5. Pull the fan away from the chassis.
To install the main rear fan, reverse the previous steps.
Note: After guiding the four rubber extensions through the apertures on the
SCSI fan
Complete the following steps to remove the SCSI fan:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover (see "Removing the cover of the 6226" on page 60).
3. Disconnect the fan cable from the system board.
and power cords.
extensions on the fan.
chassis, use needle-nosed pliers to pull the extensions firmly through.
and power cords.
FRU information (service only)
87