Changing Bulb For Inside Light - Electrolux EDC 5372 User Information

Problem
Drying cycle ends shortly
after programme starts.
END (ENDE) display illu-
minated.
Drying cycle lasts an un-
usually long time.
Note:
After around 5 hours the
drying cycle ends auto-
matically (see „Drying
cycle complete").

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The special
bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a per-
manent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly be-
hind the loading aperture, at the top; refer to "Description of machine"
section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety, the covering bonnet must be
screwed down tightly. If this is not done, the dryer must not be operated.
Possible cause
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Lint filter clogged.
Heat exchanger clogged with
lint.
SPECIAL CARE (SCHON) but-
ton pressed and load volume
too big.
Load volume too big.
Laundry insufficiently pre-
drained.
Remedy
Select time programme or higher
drying level (e.g. INTENSIVE DRY
[STARKTROCKEN] instead of
STORAGE DRY [SCHRANK-
TROCKEN]).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE (SCHON) is only
suitable for use with loads of up
to 3kg!
Reduce load volume.
Laundry must be adequately pre-
drained.
21