Changing Bulb For Inside Light - Electrolux EDC 5369 User Information

Problem
When pressing a button, the
corresponding button flashes
several times.
Drum light does not work.
Programme inactive, EMPTY
WATER (BEHÄLTER) display
illuminated.
Drying cycle ends shortly after
programme starts. END
(ENDE) display illuminated.
Drying cycle lasts an unusual-
ly long time.
Note:
After up to 5 hours the drying
cycle finishes automatically
(see "Drying cycle complete").
Changing bulb for inside
light
Only use a special bulb which is designed specially
for dryers. The special bulb is available from the af-
ter-sales service, ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
1
Warning! Before replacing the bulb, discon-
nect the mains plug; with a permanent con-
nection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this
can be found directly behind the loading aperture,
at the top; refer to "Description of machine" sec-
tion.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety,
the covering bonnet must be screwed down
tightly. If this is not done, the dryer must not
be operated.
18
Possible cause
Washing protection. After the start of
the programme, the option can no
longer be set.
Programme selector in OFF (AUS)
position.
Defective lamp.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for select-
ed programme.
Lint filter clogged.
Heat exchanger clogged with lint.
SPECIAL CARE (SCHON) button
pressed and load volume too big.
Load volume too big.
Laundry insufficiently pre-drained.
Remedy
Turn the programme knob to OFF
(AUS). Set the programme again.
Turn programme selector to LIGHT (BE-
LEUCHTUNG) or to any programme.
Replace lamp (see next section).
Empty condensate tank, then start pro-
gramme with START/PAUSE button.
Select time programme or higher drying
level (e.g. INTENSIVE DRY [STARK
TROCKEN] instead of STORAGE DRY
[SCHRANK TROCKEN]).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE (SCHON) is only suita-
ble for use with loads of up to 3kg!
Reduce load volume.
Laundry must be adequately pre-
drained.