Changing Bulb For Inside Light - Electrolux EDC 5371 User Information

Problem
Loading door does not close.
When a button is pressed,
Err appears in the multi-dis-
play.
Drum light does not work.
PROGRAMME TIME
(LAUFZEIT) display changes
erratically or stays unchanged
for a long time.
Programme inactive, EMPTY
WATER (BEHÄLTER) display
illuminated.
Drying cycle ends shortly after
programme starts. END
(ENDE) display illuminated.
Drying cycle lasts an unusual-
ly long time.
Note:
After around 5 hours the dry-
ing cycle ends automatically
(see „Drying cycle complete").

Changing bulb for inside light

Only use a special bulb which is designed specially
for dryers. The special bulb is available from the af-
ter-sales service, ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
1
Warning! Before replacing the bulb, discon-
nect the mains plug; with a permanent con-
nection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this
can be found directly behind the loading aperture,
at the top; refer to "Description of machine" sec-
tion.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety,
the covering bonnet must be screwed down
tightly. If this is not done, the dryer must not
be operated.
18
Possible cause
Fine strainer not in place and/or
large mesh filter not locked in place.
Washing protection. After the start of
the programme, the option can no
longer be set.
Programme selector in OFF (AUS)
position.
Defective light bulb.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for select-
ed programme.
Lint filter clogged.
Heat exchanger clogged with lint.
SPECIAL CARE (SCHON) button
pressed and load volume too big.
Load volume too big.
Laundry insufficiently pre-drained.
Remedy
Install fine strainer and/or snap large
mesh filter into place.
Turn the programme knob to OFF
(AUS). Set the programme again.
Turn programme selector to LIGHT (BE-
LEUCHTUNG) or to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty condensate tank, then start pro-
gramme with START/PAUSE button.
Select time programme or higher drying
level (e.g. INTENSIVE DRY [STARK-
TROCKEN] instead of STORAGE DRY
[SCHRANKTROCKEN]).
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE (SCHON) is only suita-
ble for use with loads of up to 3kg!
Reduce load volume.
Laundry must be adequately pre-
drained.