Compaq ProLiant ML350 Maintenance And Service Manual page 85

3-30 Compaq ProLiant ML350 Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
1778-Drive Array
resuming
Automatic Data
Recovery process
1779-Slot X Drive
Array –
Replacement
drive(s) detected
OR previously
failed drive(s) now
operational:
Port Y: SCSI ID Z:
Restore data from
backup if
replacement
drive X has been
installed.
1780-Disk 0
Failure
1781-Disk 1
Failure
continued
Audible Beeps Probable Source of
Problem
None This message
displays whenever a
controller reset or
power cycle occurs
while Automatic Data
Recovery is in
progress.
None Intermittent drive
failure and/or possible
loss of data detected.
None Hard drive/format
error detected.
None Hard drive/format
error detected.
Action
No action necessary.
If this message displays and drive X has
not been replaced, this indicates an
intermittent drive failure. This message
also displays immediately following drive
replacement whenever data must be
restored from backup.
Run Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace failed
assembly as indicated.
continued