Compaq ProLiant ML350 Maintenance And Service Manual page 64

Table 3-2
POST Error Messages
continued
Error Code Audible Beeps
(Run System None
Configuration Utility
– F10 key)
Unsupported 1 long, 1 short
Processor
Detected System
Halted
101-ROM Error 1 long, 1 short
101-I/O ROM Error None
102-System None
Board Failure
104-ASR-2 Timer None
Failure
105-Current 2 long
System ROM is
corrupt – now
booting redundant
System ROM
162-System 2 short
Options Not Set
163-Time & Date 2 short
Not Set
164-Memory Size 2 short
Error
172-Configuration None
Non-volatile
Memory Invalid
173-Slot ID None
Mismatch
Probable Source of Action
Problem
A configuration error Press F10 to run server setup utility.
occurred during
POST.
Processor not Check documentation for supported
supported by current processors. If supported, remove the
system ROM. processor and update system to latest
ROM, then reinstall processor.
System ROM Run Diagnostics. Replace failed
checksum. assembly as indicated.
Options ROM Run Diagnostics. Replace failed
checksum. assembly as indicated.
8237 DMA Replace the system board. Run the
controllers, 8254 Compaq server setup utility.
timers, and so on.
System board failure. Run Diagnostics. Replace failed
assembly as indicated.
Nonbooted ROM Flash the ROM utilizing ROMPaq. Refer
image is corrupted. to the ROMPaq Disaster Recovery
section of this guide.
Configuration Run the server setup utility and correct.
incorrect.
Invalid time or date Run the server setup utility and correct.
in configuration
memory.
Configuration Run the server setup utility and correct.
memory incorrect.
Nonvolatile Run the server setup utility and correct.
configuration
corrupted.
Board replaced, Run the server setup utility and correct.
configuration not
updated.
Diagnostics and Troubleshooting 3-9
continued