Replacing the Server Feature Board Battery
To remove and replace a lithium battery on the system board:
1. Complete the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the access panel. See "Access Panel" earlier in this chapter.
3. Locate the battery (1) on the system board.
4. Gently pull on the battery release lever while sliding the battery (2) out of its holder.
NOTE: If you have expansion boards installed, you may need to remove them in order to gain access to
the battery.
Figure 2-35. Locating and removing the battery from the Server Feature Board
Reverse steps 1 through 3 to replace the battery.
IMPORTANT: The battery should be installed with the positive polarity (+ side) positioned up.
1
Removal and Replacement Procedures 2-39
2