Configuring Tacacs+ On The Switch; Before You Begin; Cli Commands Described In This Section - HP procurve switch 2650 Access Security Manual

Configuring TACACS+ on the Switch

Before You Begin

If you are new to TACACS+ authentication, HP recommends that you read the
"General Authentication Setup Procedure" on page 2-6 and configure your
TACACS+ server(s) before configuring authentication on the switch.
The switch offers three command areas for TACACS+ operation:
show authentication and show tacacs: Displays the switch's TACACS+


configuration and status.
aaa authentication: A command for configuring the switch's authenti-


cation methods
tacacs-server: A command for configuring the switch's contact with


TACACS+ servers

CLI Commands Described in this Section

Command
show authentication
show tacacs
aaa authentication
console
Telnet
num-attempts <1..10 >
tacacs-server
host < ip-addr >
key
timeout < 1 ..255 >
Page
2-10
2-10
pages 2-11 through 2-14
pages 2-15
pages 2-15
2-19
2-20
TACACS+ Authentication

Configuring TACACS+ on the Switch

2-9