Installation - Triumph Speed Triple Service Manual

6. Turn the locking nut anticlockwise to release the
liner.
Note:
0
The tool must be used to release the seal
between the liner and the crankcase.
It is not intended that the tool is used to
fully extract the liner. Once the seal is
released, the tool must be removed and
the liner extracted by hand.
Installation
Note:
0
The liners have a large chamfer at the
(.
bottom of the bore enabling fitting of the
piston without need for a piston ring
compressor.
A
Caution
I
Fit each liner over whichever piston is at TDC.
When turning the engine, do not allow the pistons to
contact the inside of the crankcase and also do not
allow fitted liners to lift off the crankcase base.
1. Thoroughly clean the liner removing all traces of
old silicone sealer.
2. Remove all traces of sealer from the crankcase
bores.
3. 'Apply silicone sealer to the liner to crankcase
mating face.
ccvk
1. Liner
2.
Sealer Area
4. Fit each liner over the piston using a gentle
rocking motion to allow compression of the piston
rings.
Arrowed: Liner-piston fitment
5.
Continue fitting each liner in turn until all are
fitted and sealed.
Note:
0
When the liners have been fitted, they
should not be disturbed. If it is necessary
to remove the liner after fitting, the sealer
must be re-applied.
5.1 6
Service Manual
-
Speed Triple