Triumph Speed Triple Service Manual page 117

Transmission
6. Fit a new circlip (9) to the input shaft ensuring 11. Fit the thrust washer (4) adjacent to second gear
that the circlip is located in the circlip groove.
and slide on the needle roller bearing (3).
1. Thirdlforth gear 1. Second gear
2. Thrust washer
2. Thrust washer
3 . Circlip
12. Finally, fit the bearing sleeve (1) to the needle
7. Fit the thrust washer (8) to the input shaft and roller bearing.
slide up the shaft until in contact with the circlip.
8.
Fit the splined bush (7) from sixth gear taking
care that the oil hole in the shaft aligns with the
hole in the bush.
9. Fit sixth gear (6) with the dog teeth facing third/
fourth gear.
1. Sixth gear
2. Splined bush
10. Fit second gear (5) with the stepped side facing
away from the clutch end of the input shaft.
Service Manual
-
Speed Triple