Triumph Speed Triple Service Manual page 289

Rear Suspension
I I
10. Using the new link supplied with the chain kit,
join the two ends of the chain. Ensure that the
'0' rings are positioned as shown below and the
link plate is fitted with its markings facing
outwards.
15. Slide the link plate holder into the 'U' shaped
holder and locate it on the end of the pin. Ensure
the pin is correctly located in the link plate
holder circular cutout.
)
C8mW
1. '0' rings
2. Link
3. Link plate
11. Insert the pin into the pin holder so its larger
diameter end (riveting point) is facing away from
holder as shown.
c a m
1. Tool body and pin holder
2. Pin
12. Position the 'U' shaped holder behind the chain
ensuring its A and B marks are uppermost.
13. Slide the tool body assembly onto the 'U' shaped
holder, ensuring its adjustment screw is
uppermost.
14. Align the A mark on the U-shaped holder with
the tool body adjustment screw ensuring the
adjustment screw spring-loaded ball locates
correctly in the holder indent (see step 5).
16. Locate both the split link pins in the circular
cutouts in the 'U' shaped holder then screw the
pin holder in until the plate holder contacts the
link plate.Ensure both the split link and link
plate are correctly located in their holders
17. Retain the tool body with a wrench then tighten
the pin holder until the link plate is pressed fully
onto the link.
18. Back off the pin holder then slide the tool
assembly to one side and check that the split link
is correctly assembled.
19. Remove the link plate holder from the tool.
20. Slide the tool body along the 'U' shaped holder
until the B mark on the holder is aligned with the
adjustment screw. Ensure the adjustment screw
spring-loaded ball is correctly located in the
holder indent.
1. 'U' shaped holder B mark
2. Tool bidy adjustment screw and locknut
Sewice Manual
-
Speed Triple