Triumph Speed Triple Service Manual page 233

Fuel SystemlEngine Management
Fuel Deliverv Svstem
I
I . .
Fuel is delivered to injectors by a pump located inside
the fuel tank. Fuel flows in the direction of the arrows
shown in the diagram below.
4. Connect the adapter between the fuel pump
plate outlet and fuel hose as shown in the
illustration below, Insert the gauge to the
adapter also as shown in the illustration.
(adapter 'A' for 2°05-0wnards 'peed Triple). Use
of an incorrect adapter will result in a fuel leak. A
fuel leak can result in a fire causing damage to
property and injury to persons.
1 . Fuel pump plate outlet
2. Fuel hose
3. Tool T3880001
Incorporated in the system is a filter, a pressure
regulator and a pick-up strainer.
Note:
*
To release the fuel pressure gauge from
the adapter, slide the outer ferrule
downwards. This will allow the gauge to
spring upwards from the adapter.
*
To insert the gauge to the adapter, push
1 1
the gauge spigot in to adapter until a click
can be heard.
5. Ensuring the gauge is visible to the side of the
motorcycle, lower the fuel tank into position.
6. Start the engine and observe the fuel pressure
reading on the gauge.
Note:
*
The fuel pressure should be 3.0 bar
nominally.
7.
When fuel pressure checking is complete, have
an assistant raise the fuel tank and disconnect
the fuel pressure gauge adapter.
8. Reconnect the fuel hose and refit the fuel tank
(see page 10-88).
Sewice Manual
-
Speed Triple