Triumph Speed Triple Service Manual page 141

ngine RemovallRefit
Installation
1. T3880290
2. Adjuster
21. Slacken the drag link pivot bolt.
1. Drag
Link
Pivot Bolt
22. Place a support beneath the engine and ensure
that the frame is still adequately and securely
supported.
23. Remove the frame to head bracket from the left
hand side of the motorcycle.
24. Remove the remaining engine mounting bolts
and lower the engine sufficiently to allow the
drive chain to be detached from the outp'ut
sprocket.
25. Remove the engine from the frame.
A
Caution
1
I
To prevent damage to components, lower the engine
(
very carefully. Particularly vulnerable items include
the radiator.
1. Position the engine beneath the frame.
2. Raise the engine, looping the drive chain over
the output sprocket as it is raised.
3. Align the engine to the frame and refit the engine
mounting bolts to support the engine.
4. Refit the frame to cylinder head bracket to the left
hand side of the motorcycle. Tighten the bracket
to cylinder head bolts to 30 Nm. DO NOT
TIGHTEN THE BRACKET TO FRAME BOLT
UNTIL INSTRUCTED TO DO SO.
A
Caution
I
Unless the following engine mounting bolt tightening
I
sequence is precisely followed, severe frame
damage can occur.
5. Remove the support from beneath the engine.
6. Tighten the bolt securing the frame to the left
hand front cylinder head mounting to 80 Nm.
7. Tighten the bolt securing the frame to the rear
left hand upper engine mounting to 80 Nm.
8.
Tighten the bolt securing the frame to the rear
left hand lower engine mounting to 80 Nm.
9.
Check the gap between the frame and engine at
all four right hand engine mounting locations. If a
gap is found between the engine and frame, add
spacers as necessary to eliminate the gap.
10.
If
a spacer is needed for the lower right hand rear
engine mounting bolt, a spacer (part number
T3550355) must also be fitted to the drag link to
frame bolt on the right hand side.
Note:
Four sizes of spacer are available, 2 mm,
1.5 mm, 1.0 mm and 0.5 mm. Refer to the
parts catalogue for part number
information.
11. Once all the necessary spacers have been
added, tighten the bolt securing the frame to the
right front cylinder head mounting to 80 Nm.
12. Tighten the bolt securing the frame to the right
hand rear cylinder head mounting to 80 Nm.
13. Tighten the bolt securing the frame to the rear
right hand upper engine mounting to 80 Nm.
14. Tighten the bolt securing the frame to the rear
right hand lower engine mounting to 80 Nm.
15. Tighten the bolt securing the frame to the
cylinder head mounting bracket on the left side of
the cylinder head to 80 Nm.
Service Manual
-
Speed Triple
9.3