Triumph Speed Triple Service Manual page 370

5. To remove the stator from the cover, release the
three bolts in the centre of the cover and release
the bolt securing the cable bracket.
8.
With the bolt removed, locate the spigot from the
larger of the two thrust pads supplied with tool
T3880365 to the crankshaft.
1. Stator
2. Stator bolts
3. Cable bracket
4. Cable bracket bolt
6. Withdraw the stator.
7.
To remove the rotor, prevent the crankshaft from
rotating using tool T3880375, and remove the
centre bolt from the crankshaft.
1. Rotor
2. Tool 13880375
1. Thrust pad
9. Assemble tool T3880365 to the threaded centre
section of the rotor.
(
Note:
Ensure that the thrust pad does not fall out
during assembly of the tool.
10. Hold the centre of the tool to prevent rotation
then tighten the draw-bolt in the centre of the tool
to release the taper seating of the rotor from the
crankshaft.
1. Rotor
2.
Tool T3880365
11. Withdraw the rotor and tool as an assembly and
then separate the tool from the rotor.
17.14
Sewice Manual
-
Speed Triple