Sip Ports - Snom ONE IP Technical Manual

Deploying the snom ONE IP Telephone System
54
interface). The HTTP port is used for insecure, but lightweight, communication. The
HTTPS port is used for communication that is secure, but a bit more expensive.
If you cannot reach the system on any port, change the
https_port parameters in the global configuration file (the defaults are shown
below). If you are running another service on your host or if you want to gain some
additional security, you may change these ports to any other available port. The system
will fail to start if it cannot bind to the port.
•
HTTP Port: The default HTTP port is
•
HTTPS port: The default HTTPS port is

SIP Ports

In this section, you can provide specific port information for the SIP protocol. SIP can
run on UDP, TCP, or TLS. TCP and UDP send the SIP packets unencrypted and are
therefore considered insecure. TLS is used for secure SIP communication since it en-
crypts the SIP signalling packets much like HTTPS encrypts HTTP traffic. The default
SIP port per RFC 3261 is 5060 for SIP and 5061 for SIPS. The snom ONE software is
listening for and transmitting SIP requests and responses on these ports.
* Changes to HTTP and SIP settings require a system restart.
•
SIP UDP Ports: If you are using SIP over UDP, you need to set this field.
The default port for UDP is
5060 5064
•
SIP TCP Ports: If you are using SIP over TCP, you need to set this field. The
default port for TCP is
5060
).
5060 .
ip_http_port
80 .
443 .
, but multiple ports are permitted (e.g.,
and ip_