Configuring The Snom One Server - Snom ONE IP Technical Manual

Configuring the snom ONE Server

Create a new trunk to connect to Exchange:
1. Click the Trunks tab.
2. Name the new trunk
3. Set its type to SIP Gateway.
4. Click the Create button.
5. From the list of trunks, click
6. In the Domain field, enter the FQDN or IP address of your Exchange Server
(i.e., exchange.company.com
7. In the Proxy Address field, enter
com:5060;transport=tcp
the FQDN or IP address of your Exchange Server. The example assumes the ad-
100.200.100.200
dress is
8. Enable Accept Redirect.
9. If you want the PBX to do in-band DTMF to out-of-band DTMF (RFC 4733)
transcoding on this trunk, set Trunk requires out of band-DTMF tones to
Yes. For this to work properly, Inband DTMF detection must be set to on (go
to Admin > Settings > General).
10. Click Save.
Appendix C: snom ONE and Exchange
MS-Exchange
or any suitable name.
MS-Exchange
).
sip:exchange.company.
, but replace
.
.
exchange.company.com
531
with