Disassembling And Assembling; General - Siemens E382 EH81E 061 01 03 02 Service Manual

Disassembling and assembling

Before any compressor cover or the front
panel is opened or removed, make sure
that the mains power supply is
disconnected and that the compressed
air reservoir is depressurized.
With mains power supply connected to
the unit, there are energized electrical
components as well as moving
mechanical parts inside the equipment.
All personnel must exercise extreme
caution when in the vicinity of this
equipment if fault tracing or adjustments
are performed with mains power supply
connected and with the compressor
cover or front panel opened or removed.
After any service intervention in the
Compressor Compact, perform a
Functional check according to
instructions in the Operating Manual.
22
Disassembling and
assembling

General

• This chapter describes disassembling and
assembling of some of the main parts of
the Compressor Compact. The drawings in
the Spare Parts List are also useful as a
guide when disassembling and assembling
the Compressor Compact.
• To avoid the possible spillage of water,
before disassembling the Compressor
Compact run the unit until the solenoid
valves in the dryer section operate to drain
water into the drainage bottle. Then
remove the drainage bottle, empty the
bottle and refit it.
• Wait for the Compressor Compact to cool
down before proceeding.
• Locking or sealing compounds are used on
many of the screwed connections. Detailed
information can be found in the Spare
Parts List. Old locking and sealing
compound must be removed and the
threads must be cleaned before any new
compound is applied.
Siemens-Elema AB
Compressor Compact
E382 EH81E 061 01 03 02