Programming Navigation; Navigation Arrows & Go To Button; Questions Without Sub-Options; Questions With Sub-Options - 2gig Technologies Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Wireless security system

Hide thumbs Also See for Go!Control 2GIG-CNTRL2:

Operation and user's manual (52 pages)

User manual (56 pages)

Table Of Contents

Table of Contents

When the installer is using the System Conﬁ guration menus,

the Control Panel will present each programming question

sequentially. Most programming questions have a single numeric

value response or a simple enabled/disabled selection. Some

programming questions have sub-options that can be set. These

sub-options are displayed for the question selected and can be

accessed through navigation keys on the display.

Navigation Arrows & Go To Button

The programming question screens display up, down, left, and

right navigation arrows. They are used to move through the

programming questions and sub-options.

The GO TO button is used to jump directly to a programming

question. Pressing GO TO will prompt the installer for the two-digit

question number to jump to. The GO TO button changes to CANCEL

while waiting for a question number, press CANCEL to back out.

Questions without Sub-options

Most of the programming questions do not have sub-options. They

navigate as follows. Questions without sub-options do not

display a SKIP button.

• The ↑ & ↓ arrows select the next or previous programming question.

• The ← & → arrows choose values for the question or move the cursor left

and right along the white data entry ﬁ eld.

Questions with Sub-options

Some of the programming questions have sub-options. They

navigate as follows. Questions with sub-options display a SKIP

button during the question.

• The SKIP button advances to the next programming question/section.

• The ↑ & ↓ arrows select the next or previous programming sub-question.

• The ← & → arrows choose values for the question or move the cursor left

and right along the white data entry ﬁ eld.

Questions with Data to Enter

Some of the programming questions require entering numeric or

alphabetic data. For devices that can be named, the Control Panel

contains a large vocabulary with words to choose from (see Pg. 19).

• The INSERT button displays a word from the vocabulary. The words can

be scrolled through using the ← & → arrows, or selected by entering their

3-digit index number.

• The

(backspace) button moves the cursor to the left, deleting the one

character at a time.

• The

(delete) button deletes a character to the right of the cursor, or any

characters that are highlighted.

• The FWD (forward) button highlights the next word in multi-word data ﬁ elds.

• The BACK button highlights the previous word in multi-word data ﬁ elds. The

BACK button displays the previous screen in some cases.

• When the SHIFT button is displayed, pressing it will display alternate

characters on the keypad that can be used for data entry.

Other Buttons Displayed

Depending on the programming question, other buttons may be displayed.

• The ESC (escape) button serves as an "undo". Pressing ESC restores the

value that was previously stored for the question or sub-question.

• The SUM (summary) button displays a summary of the values stored for the

programming question and sub-options.

• The END button displays a summary of the values stored for the entire

Control Panel memory.

• The LEARN button is used to set the system to receive a sensor's serial

number when transmitted during programming the wireless sensors.

• The PASTE button repeats the last sensor serial number entered.

• The EXIT button exits programming.