Rf Keypad Programming; Rf Keypad Programming Outline; Rf Keypad Summary Screen - 2gig Technologies Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Wireless security system

Hide thumbs Also See for Go!Control 2GIG-CNTRL2:

Operation and user's manual (52 pages)

User manual (56 pages)

Table Of Contents

Table of Contents

Installer Programming

RF Keypad Programming

RF Keypad Programming Outline

The Control Panel can be programmed with up to four RF remote

control keypads or wireless touch screen keypads.

Programming RF keypads into the Control Panel involves selecting

the sensor number for a particular device, setting or learning the

keypad's serial number, and selecting the other options for the

keypad.

• RF keypads #1 - #4 report as system sensors

#59 - #62 for emergency, and low battery reports.

RF KEYPAD REPORTING CODES

RF keypad #1

RF keypad #2

RF keypad #3

RF keypad #4

• User Codes #1 - #8 are reported for openings and closings.

• User Code #0 is reported for Quick Arming.

Refer to Figure 56 for an outline of the steps required to program

RF remote control keypads into the Control Panel. The options that

can be set for each RF remote control keypad are:

• RF Keypad Number — Keypad number 1-4

• RF Keypad Used — Keypad used or not

• RF Keypad Equipment Code — Sensor model

• RF Keypad Other Equipment Code — Enter special

equipment code (only shown for sensors set as "other")

• RF Keypad Serial # — Serial number labeled on

keypad; hand enter or "learn" by sending signal

• RF Keypad Equipment Age — New unit or existing keypad

• RF Keypad Emergency Keys — Enable

or disable keypad emergency keys

• RF Keypad Voice Descriptor — Name

assigned to the keypad

RF Keypad Summary Screen

After setting all the options for a sensor, the RF keypad summary

screen is displayed. The screen can also be displayed for

programmed RF keypads during RF keypad program editing by

pressing the SUM button.

• The ← and → arrow buttons step through the RF keypad numbers.

• The EDIT CURRENT and EDIT NEXT buttons return to RF keypad

programming.

• Pressing SKIP goes to question Q-5 (Control Panel programming).

Figure 55. RF Keypad Summary Screen

Reports as sensor #59

Reports as sensor #60

Reports as sensor #61

Reports as sensor #62

KEYPAD PROGRAMMING (Q-4) OUTLINE

STEP DOWN

THROUGH OPTIONS

SELECT RF KEYPAD #

PRESS

FOR NEXT OPTION

SELECT RF KEYPAD

USED

PRESS

FOR NEXT OPTION

SELECT RF KEYPAD

EQUIPMENT CODE

PRESS

FOR NEXT OPTION

ENTER RF KEYPAD

OTHER EQUIPMENT CODE

(ONLY FOR "OTHER" EQUIPMENT)

PRESS

FOR NEXT OPTION

ENTER RF KEYPAD

SERIAL NUMBER

PRESS

FOR NEXT OPTION

SELECT RF KEYPAD

EQUIPMENT AGE

PRESS

FOR NEXT OPTION

SELECT RF KEYPAD

EMERGENCY KEYS

(ONLY FOR NON-TS1 KEYPADS)

PRESS

FOR NEXT OPTION

CONSTRUCT RF KEYPAD

VOICE DESCRIPTOR

PRESS

TO FINISH FOR THIS SENSOR, THEN

Figure 56. RF Keypad Programming Outline

SELECT OPTION WITH

THESE KEYS