2gig Technologies Go!Control 2GIG-CNTRL2 Installation & Programming Instructions page 40

Installer Programming
Q-84
Select services require master code (0-1)
DEFAULT: Disabled (0)
The SERVICES button can be confi gured to require the use of the Master User
Code to access Services.
• The default (0) disables the requirement for the Master
User Code to access the SERVICES menu.
• To require the use of the Master User Code to access
the SERVICES menu, select enabled (1).
When enabled then the Master User Code is required to access the Services and
the Z-wave device confi gurations. This keeps unauthorized users from being able
to change Z-wave settings, such as temperature, lights and locks.
Q-85
Select master user access to zwave toolbox (0-1)
DEFAULT: Disabled (0)
The Z-Wave Toolbox menu can be set to require the use of the Master User Code
or the Installer Code. By default, the Installer Code is required for users to access
the Z-Wave Toolbox.
• The default (0) requires the use of the Installer Code to access the Z-Wave
Toolbox menu and all of its features, including the Advanced Toolbox.
• To require the use of the Master User Code or the Installer Code
to access the Z-Wave Toolbox menu, select enabled (1).
✓ NOTE: When enabled (1) the Installer code will still be required
to access the Advanced Toolbox menu. This prevents end
users from adding or removing Z-Wave devices.
Q-86
Select disable siren after two-way audio (0-1)
DEFAULT: Disabled (0)
This setting enhances system operation in personal emergency applications and
also provides the dealer with the option of the siren sounding until the bell cut off
or to the end of a two-way-voice session.
• The default (0) will cause the siren to resume after two-way
audio (if the bell cut off timer has not expired).
• Enable (1) will cause the siren to shut off after a two-way audio session.
Q-87
Select keyfob/remote arming mode
on system not ready (0-2)
DEFAULT: Auto bypass with zone participation on restore (0)
This setting controls how the system will react when there are open sensors and
the system is armed remotely.
• The default (0) will automatically bypass all sensors that
are open when the system is armed remotely. If a sensor
restores while the system is armed, the sensor's bypass will be
removed, and the sensor will be ready to trigger an alarm.
• To automatically bypass all sensors that are open when the system
is armed remotely, and keep all bypasses in place during the
arming cycle, even if a sensor restores, select auto-bypass (1).
• To prevent arming remotely when any sensor is
open, select arm only when ready (2).
38
Q-88
Select siren mode (0-1)
DEFAULT: Sound for burglary and fi re/CO (0)
This setting selects which alarm types will activate a Z-Wave siren linked to the
system.
• The default (0) will cause a Z-Wave siren to sound
during burglary and fi re/CO alarms.
• To have a Z-Wave siren sound only during burglary
alarms, select sound for burglary only (1).