Optional Gsm Module Installation - 2gig Technologies Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Installation

Optional GSM Module Installation

If using the optional GSM module and one of the GSM antennas.
Refer to the following steps:
1. Plug the GSM module into the connector on the Control Panel's circuit
board. Secure it with the two screws.
2A. If using the Model 2GIG-ANT1 internal antenna, remove the antenna
access cover. Route the antenna lead through the opening in the case and
place the fl at antenna into the slot. Route the antenna wire under the clip
behind the speaker and plug the antenna connector into the GSM module.
Replace the antenna access cover. See Figure 13.
✓ NOTE: The routing of the GSM antenna wire is very critical.
Route the wire as directed or GSM radio interference will occur
inside the Control Panel.
2B. If using one of the external antennas, simply plug the antenna connector
into the GSM module. The antenna will drop into the wall or mount in
the attic with the cable passing through the slot in the Control Panel's
mounting plate. See Figures 14 & 15.
✓ NOTE: The GSM SIM card should have been pre-activated by
the factory; if not, contact your service provider. For the GSM
module to function with the system, it will have to be activated
before it can be enrolled by creating an account with the
service provider.
ANTENNA HANGS
DOWN INSIDE WALL
Figure 14. ANT1X In-wall GSM Antenna Installation
10
GSM CONNECTOR
2GIG-ANT1X
ANTENNA
3
PLACE
ANTENNA
INTO SLOT
AS SHOWN
4
SECURE GSM
MODULE WITH
TWO SCREWS
ROUTE GSM ANTENNA CABLE
EXACTLY AS SHOWN !!!
Figure 13. Optional GSM Module Installation
COAX TO
CONTROL
PANEL
Figure 15. ANT2X Attic GSM Antenna Installation
1
PLUG GSM
MODULE INTO
CONTROL
PANEL
2
PRY OPEN
ANTENNA ACCESS
COVER
ROUTE GSM ANTENNA CABLE
EXACTLY AS SHOWN !!!
2GIG-ANT2X
GSM ANTENNA
MOUNTED AS HIGH
AS POSSIBLE