Regulatory Information & Limited Warranty; Wireless Product Notice; Fcc Notice; Fcc Telephone Rules And Regulations - 2gig Technologies Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Wireless security system
Hide thumbs Also See for Go!Control 2GIG-CNTRL2:
Table of Contents

Advertisement

Regulatory Information & Limited Warranty

Wireless Product Notice

Radio controls provide a reliable communications link and fi ll an
important need in portable wireless signaling; however, there are
some limitations which must be observed.
• For U.S. installations only: The radios are required
to comply with FCC Rules and Regulations
as Part 15 devices. As such, they have limited
transmitter power and therefore limited range.
• A receiver cannot respond to more than one
transmitted signal at a time and may be blocked by
radio signals that occur on or near their operating
frequencies, regardless of code settings.
• Changes or modifi cations to the device
may void FCC compliance.
• Infrequently used radio links should be tested regularly
to protect against undetected interference or fault.
• A general knowledge of radio and its vagaries should be
gained prior to acting as a wholesale distributor or dealer, and
these facts should be communicated to the ultimate users.

FCC Notice

This equipment generates and uses radio frequency energy and if
not installed and used properly, that is, in strict accordance with the
manufacturer's instructions, may cause interference to radio and
television reception. It has been type tested and found to comply
with the limits for a Class B computing device in accordance with
Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Relocate the Console away from the TV/radio receiver.
• Plug the Console into a different wall outlet so that
the Console is on a different branch circuit.
• Re-orient the TV/radio antenna.
• If necessary, the user should consult the
dealer or an experienced radio/television
technician for additional suggestions.

FCC Telephone Rules and Regulations

The FCC requires that this alarm dialer system not make more
than 15 repetitive dialing attempts to a single telephone number.
There are no limitations when the calls are made sequentially
to two or more alternative numbers, or when these calls are
spaced 10 minutes apart to a single number. The FCC Rules
and Regulations do not specify the re-attempt period as this can
vary for specifi c applications. When setting this period, take into
consideration local, interstate, foreign and special network call
completion characteristics, network processing time, a suffi cient
number of rings and busy/don't answer modes.

Industry Canada Notices

NOTICE: The ringer equivalence number (REN) assigned to each
terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the ringer
equivalence numbers of all the devices does not exceed 5.
NOTICE: The Industry Canada label identifi es certifi ed equipment.
This certifi cation means that the equipment meets certain
telecommunications network protective, operational and safety
requirements. The Department does not guarantee the equipment
will operate to the user's satisfaction.
Before installing this equipment, users should ensure that
it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certifi ed equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.

Limited Warranty

This 2gig Technologies Inc. product is warranted against defects
in material and workmanship for twelve (12) months. This
warranty extends only to wholesale customers who buy
through 2gig Technologies Inc. authorized distribution channels.
2gig Technologies Inc. does not warrant this product to
consumers. Consumers should inquire from their selling dealer
as to the nature of the dealer's warranty, if any. There are no
obligations or liabilities on the part of 2gig Technologies Inc.
for consequential damages arising out of or in connection
with use or performance of this product or other indirect
damages with respect to loss of property, revenue, or profi t,
or cost of removal, installation, or reinstallation. All implied
warranties, including implied warranties for merchantability and
implied warranties for fi tness, are valid only until the warranty
expires. This 2gig Technologies Inc. Warranty is in lieu of all
other warranties express or implied.
All products returned for warranty service require a Return Product
Authorization Number (RPA#). Contact 2gig Technologies Inc. at
866-670-1591 for an RPA# and other important details.
43

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2gig-ntrl2Go!control 2gig-cp2

Table of Contents