Set The Initial Tx Power For A Remote - iDirect iNFINITI 3000 Installation And Commissioning Manual

13.2 Set the Initial Tx Power for a Remote

NOTE
WARNING
Determine and set the initial transmit power as follows:
1. In iMonitor, right-click the remote in the network tree and select
menu.
2. In the
Remote Power
3. In the
Change Remote Tx Power
a. Enter -25 in
setting on another remote in the network with similar antenna, BUC and
geographic location.)
b. Increase the transmit power by increments of 3 dB until the remote
acquires into the network.
iDirect iNFINITI series Installation and Commissioning Guide, Release 7.0
You must determine the initial transmit power setting under clear
sky conditions.
Following this procedure to determine the initial transmit power for
a mesh remote while the remote is in a rain fade can result in a
power setting that is too high. This can overdrive the power on the
satellite.
area of the screen, click the
dialog box:
and click
New Tx Power
51
Probe
button.
Change
. (You can also base this initial
Set
from the