Table of Contents
Advertisement
DC-DC Power Supply Assembly at a Glance
Table E-2. Power Module Power Cable Installation Instructions Detail
Step
1.
Strip approximately 1/4 inch of insulation
from the ends of three appropriately sized
(14-18 AWG) DC input wires.
2.
Loosen the three screws on the terminal
block plug . Insert DC (-), DC (+), and
ground wires into the corresponding
terminals of the DC terminal block plug.
Fasten the three screws securely. Do not
over-tighten.
3.
Insert the cable tie through one of the
holes in the right half of the strain relief
clip.
42
Figure E-1. DC-DC Power Supply Assembly at a Glance
Instructions
Diagram
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Hide quick links:
Advertisement
Table of Contents
