Appendix C Disabling the PWM Voltage through iBuilder
In release 6.0 or above, if you have access to iBuilder, you can verify that the transmit PWM
voltage normally present on the transmit IFL cable is disabled.
To verify the transmit PWM voltage normally present on the transmit IFL cable is disabled through
iBuilder complete the following procedure.
1.
Power up the Satellite Router and let it boot up completely.
2.
In iBuilder, right-click on the remote and select modify.
3.
In the Modify Configuration dialog box, make sure that the Disable Tx PWM
check box is selected.
4.
Reset the Satellite Router.
iDirect iNFINITI series Installation and Commissioning Guide, Release 7.0
65